135
rogramación de los teléfonos T-740 Plus.
P
To show that the system is ready for programming,
the door panel and the telephone's handset will
reproduce a tone (the telephone led will light).
Audio communication can be established.
Press the door panel push button that will call to
this telephone. At this moment both door
panel and handset will reproduce tones (the
telephone led will slow blink).
To programm the telephone as
Master
, press the
h
(the telephone led will off).
Close the telephone.
ook switch
Set to ON the switch number 2 of the SW2 configuration dip switch, placed at
the upper left side (back) of the sound module. The door panel will reproduce a
sound to advise that the system has entered into programming mode. In systems
with more than one door panel, the programming process shall be done on the
master door panel only.
Each apartment must have one master unit only; in case of parallel units configure them as slaves,
both monitors or telephones.
Make a call to check that the telephone has been succesfully programmed. Repeat
these steps to program the rest of telephones.
Once the programming has been finished, set to OFF the programming switch. If
you don't, the door panel will reproduce a tone to advise that the system is still
into programming mode.
To programm the telephone as
Slave
, press the
P1 door release push button (the telephone
led will quick blink) and later press the hook
switch (the led will off).
Close the telephone.
Open the telephone to programming (see page
134). Select in the SW1 dip switch the fuction
mode for the auxiliary
(see page 133) and later press the P3
programming push-button.
function push button
To programm the telephone as
Slave +
Intercom.
, press the P2 auxiliary function
push button (the led will quick blink) and later
press the hook switch (the led will off).
Close the telephone.
To program the telephone from a general door panel (if it exists), see page 119.
TELEPHONES PROGRAMMING
P3
1
2
P3
ON
P3
ON
P3
ON
P3
ON
P3
SW1
1
2
P1
P2
CN1
M
S
SI
P1
P2
CN1
P3
SW1
P1
P2
CN1
ON
P3
ON
P3
SW1
P1
P2
CN1
ON
P3
SW1
P1
P2
CN1
ON