131
TELEPHONES PROGRAMMING
rogramming the T-940 Plus telephones.
P
Switch off the telephone to be programmed.
Once the telephone is off, press the door release push button.
Set to ON the switch number 2 of the SW2 configuration dip switch, placed
at the upper left side (back) of the sound module. The door panel will
reproduce a sound to advise that the system has entered into
programming mode.
In systems with more than one door panel, the programming process shall
be done on the master door panel only.
To program the telephone from a general door panel (if it exists), see page 119.
To show that the system is ready for programming, the door
panel will reproduce a tone and the telephone led will blink.
At this moment, the door release push button can be
released. Lift the handset to establish audio communication
with the door panel.
With the door release push button pressed switch on the
telephone.
Press the door panel push button that will call
to this telephone. At this moment the door
panel will reproduce a tone and the
telephone led will blink.
To program the telephone as master, switch it
off and on again.
To program it as slave, press the door release
push button.
To program it as slave with intercom function
press the center push button.
Each apartment must have one master unit only; in case of parallel units configure them as
slaves, both monitors or telephones.
Make a call to check that the telephone has been succesfully programmed.
Repeat these steps to program the rest of telephones.
Once the programming has been finished, set to OFF the programming
switch. If you don't, the door panel will reproduce a tone to advise that the
system is still into programming mode.
