133
.
F
unction push buttons
TELEPHONE DESCRIPTION
If the handset is on the craddle sends a panic call to the porter's
exchanges that have enabled the reception of this type of call. If not,
allows to call to the master porter's exchange. During call reception
and communication progresses allows the lock release activation.
Auxiliary function push button
, depending on setting in the SW1 dip
switch will realize one of the following functions: Autoswitch-on, "PA"
output, call to a slave porter's exchange and intercommunication.
escription of configuration dip switch.
D
escription of programming push button.
D
Factory default
"Autoswitch-on" mode: switches 1 and 2 to ON.
With the handset off the cradle, allows to stablish audio communication with the
door panel that has been configured with the autoswitch-on function. This
function is disabled if a communication is already established.
"PA" output mode: switches 1to ON and 2 to OFF:
Regardless of the handset's position, it activates the "PA" telephone output.
"C
" mode: switches 1 to OFF and 2 to ON.
With the handset off the cradle, allows to call to a porter's exchange that it is
configurated as slave.
all to a slave porter's exchange
"
" mode: switches 1 and 2 to OFF.
With the handset off the cradle, allows to make an intercom call between two units
of the same apartment.
Intercommunication
The P3 programm push button is located in the top part left of the circuit,it is
accessed by opening the telephone. Allows to telephone enter in programming
mode with the door panel, (see programming process on page 135).
IMPORTANTE:
Select
before programming the telephone.
the auxiliary function push button mode
The SW1 configuration dip switch is located in the top part left of the circuit,it is
accessed by opening the telephone and allow the next operation modes for the
auxiliary function push button:
P3
SW1
1
2
1
2
1
2
1
2
1
2
P3
1
2
