115
escription of the SW1 configuration dip-switch of
D
the sound module.
Placed to OFF if the EL631/Plus module is configured as EL500
.
Set to ON if the EL631/Plus module is configured as EL501
(general door panel).
operating
mode
operating mode
Selects the d
done from the
('AP'
terminal), see page 149.
Placed to ON: door opening timed at 3 seconds.
Set to OFF: door opening timed at 15 seconds.
oor opening time,
external push button
Selects the type of cable to be used for the video signal.
Placed to OFF: coaxial cable RG-59 o RG-11.
Set to ON: twisted pair.
Placed to OFF if the door panel has telecamera. In case of door panels
without telecamera (EL640 Plus sound module) set to ON.
Plus system
, loads the installation with a communications resistor
Plus
. For a
proper system operation, placed to ON only in the closest door panel to the
backbone installation or in the general door panel (if exists), set the rest to
OFF.
Set to ON so that the volume tone emitted by the door panel:
(call reception, busy system and lock release) are
HIGH,
or placed to OFF if a
LOW
volume tone is desired.
Uno System
,
proper system operation, set to ON only in the closest door panel to the
backbone installation, placed the rest to OFF.
With digital repeater RD Plus/Uno:
In the backbone installation or after the inner door panel in systems with
general door panels, placed the door panel/s to OFF.
loads the installation with a communications resistor
Uno
. For a
6
6
7
6
7
6
Placed to ON,
porter's exchange (if exists).Set to OFF, the call is received in the apartment.
In general door panels systems with porter's exchange, this function is only
applicable to the general door panels not to the inner door panel/s.
the calls made on the door panel will be transferred to the
Factory default
6
7
8
6
7
8
The SW1 configuration dip-switch is located at the upper right
side of the back of the module.
For dip switch settings, use the tool
that is supplied with the
sound module.
DOOR PANEL INSTALLATION
