41
O
w
w
w
O
w
O
w
O
w
O
w
O
w
N
.
R
.
C
.
C
&
.
.
39
A
.
.
.
.
.
A
39.
.
R
. C
40 & 41.
.
C
.
othing operates
emember that the monitor remains inactive for 45 seconds after connecting the power supply,
the same occurs upon connecting any unit to the installation
heck that the monitor is switched on, the
push button must have the red led on
heck that the monitor is correctly programmed, see page 40
41
Inappropriate audio volume
Adjust the audio levels as shown on page
udio feedback
Lower the door panel and / or monitor volume
If feedback doesn't disappear refer to the following hint
Continuous audio feedback
Check that the audio terminal is not shortcircuited with other terminals.
Monitor image is not correct
djust the brightness, contrast and colour levels as shown on page
The monitor does not receive calls
emember that each apartment must have only one terminal programmed as master
heck that
the terminal is correctly programmed; if necessary, program it again as shown on page
The monitor cannot be programmed
heck that the door panel is in programming mode (see the document of the door panel) and that
the programming steps of the monitor are correct (see page 40 & 41)
w
O
.
42
C
onexión de
El monitor
Permite ahorra
Tonos de llam
Durante una c
Sze
unos tonos e
Le monite
d'une so
Sonnerie
Durant un
sonore d
The
unnecesary
Szena
m
Different acou
from the apa
C
onnexi
D
oor bell con
C
onexión de
C
onnexi
A
uxiliary call
TROUBLESHOOTING HINTS
MONITOR PROGRAMMING
Q
uick programming monitors guide.
Switch off the monitor to be programmed
Once the monitor is off, press the door release push
button
.
.
With the door release push button pressed switch
on the monitor
The menu will be shown on the screen
.
.
First put the door panel in programming mode, (see document of the installed door panel).
To quit the programming mode press the
option and then press the
push button.
Press the door panel push button that will
call to this monitor. At this moment
the door panel will reproduce a sound
and the monitor led
will blink.
To programm the monitor as master, press
the
push button.
To programm it as slave, press the
door
release push button.
To programm it as slave with intercom function
press the
push button.
Once the programming has been finished quit of the door panel programming mode.
M
S
000106 M
Setup
000106 S
Setup
000106
Setup
I
000106 M
Setup