golmar SV-370S, Instruction Manual

Page: 44 / 48

43 44
ing tone
selection.
R
ntercom function.
I
It's possible to select for each monitor between four different ring tones.
To select a ring tone (system in rest):
1. Press the push button to play the selected ring tone.
2. Press the push button to play the next ring tone. Repeat this stage till find
the desired ring tone.
3. To save the desired ring tone and exit press the push button .
The monitor exit of the ring tone selection to the 40 seconds, saving the last
selected ring tone.
370S monitor, incorporate as standard the intercom function between two monitors of
the same apartment. To enable this function check the following conditions:
- The monitor that is connected to door panel(s) has been configurated as
master and slave the other monitor.
- Link the 1, 2 and 3 terminals of the units (see page 45).
To stablish an intercom communication press push button on the calling monitor:
acoustic tones will be reproduced confirming the call is in progress, the called
monitor will receive the call. To establish communication, press push button of
the called monitor.
at any of
the monitors. If during an intercom communication a call is made from the door
panel, the intercom function will be cancelled, appearing the picture in both
.
.
The communication will last for 80 seconds or until press push button
.
.
MONITOR INSTALLATION MONITOR INSTALLATION
ix the monitor.
F
Place the monitor align attaching holes of the monitor with the attachment hooks of the bracket
installation.
With help of a plain screwdriver, fix the monitor
with especified screws, as shown on the picture.
onitor wiring.
M
Connect the installation wires to the terminal connector,
according to the installation diagrams.
370S COLOR 370S COLOR
M M S S
creen
S
settings.
During call reception, communication and autoswitch-on processes,
it allows adjust the b and colour of the
screen with menu push button and select push buttons up
and down , placed in the low left zone of the monitor,
(see page 40).
rightness, contrast
Press the menú push button , and will display the (brightness,
contrast, colour and exit) options, to select one of these options
press up or down push buttons, then press the menu push
button to confirm the selection and then press the up or down push buttons to
adjust to the desired value.
To save the desired value and exit, select the option exit and then press the menu push
button to confirm.