11
10
ACCESS CONTROL PROGRAMMING
uplicated codes.
D
1
0
or
It defines the installer PIN code to enter into programming
mode.
A 6 digits code must be always used. Once this code
has been introduced, 2 acoustic tones will be heard:
introduce the code again and 4 slow acoustic tones
will be heard to confirm the changes.
Factory default: 271828.
It defines the user PIN code to enter into programming
mode.
A 6 digits code must be always used. Once this code
has been introduced, 2 acoustic tones will be heard:
introduce the code again and 4 slow acoustic tones
will be heard to confirm the changes.
Factory default: 314159.
It allows to enable or disable the acoustic signal that's
reproduced when a key is pressed. This function
hasn't effect during programming mode.
Select 0 to disable this function.
Select 1 to enable this function.
Factory default: 1 (enabled).
*
*
*
*
0
0
0
7
8
9
It's possible to activate both relays simultaneously. Simply repeat one of the activation codes
for both relays.
On systems that use the power supply included on the kit to activate the connected devices
(i.e. two lock releases) simultaneously, the maximum load of this power supply must be
calculated. If necessary, an additional power supply can be used to activate these devices.
The connection of an additional TF-104 transformer, to activate a second lock release,
is shown on page 14.
Coming from previous page
unction fields and values.
F
TELEPHONE INSTALLATION
a
d
c
e
b
a.
b.
c.
d.
e.
f.
g.
h.
Telephone handset.
Speaker grille.
Microphone hole.
Subjection hole.
Telephone cord connectors.
Additional push button.
Door release push button.
Hook switch.
To open the telephone insert
a plain screwdriver into the slots and
rotate it as shown.
Avoid to place the telephone near to heating sources,
in dusty locations or smoky environments.
The telephone can be fixed using an electrical embedding
box or directly on the wall, as shown on the picture.
If the telephone will be installed directly over the wall,
drill two holes of Ø6mm. on the specified positions,
using 6mm. wallplugs and Ø3,5 x 25mm. screws.
Pass the installation wires through
the corresponding hole and
connect them as shown on the
installation diagrams.
Close the telephone as shown on the picture.
Once the telephone is closed, connect the handset
using the telephone cord and put it on the craddle.
f
e
h
g
escription of the T-902 telephone.
D
