ACCESS CONTROL DESCRIPTION
5
4
ACCESS CONTROL PROGRAMMING
DOOR PANEL INSTALLATION
lace the nameplate labels.
P
Open the label holder.
Place the label and
close.
inal adjustments.
F
If after starting the system it's considered that the audio
volume isn't correct, proceed with the necessary
adjustments as shown.
Once the nameplate labels are placed, wire the
lamps from different modules and connect them
to terminals L1 and L2 of the sound module,
as it's shown on the installation diagrams.
lose the door panel.
C
Fix the door panel by using the supplied
screws.
Finish the door panel assembly by pressing
the closing heads.
rogramming methodes.
P
It will be necessary to enter into the programming menu to configure the system properties.
Two different programming menues are available:
installer
, that allows to modifiy any of the
system properties and
user
, that only allows to change the relay activation codes,
the user code and to disable the keypad acknowledgement signal.
Programming options with black text and white background are availables in both menues;
options with white text and black background are only availables on installer menu.
The module will automatically exit from the configuration menu after 2 minutes with no operation.
Installation terminal connector is located on the rear
part of the module. The correspondance of each
terminal is as follows:
Jumper JP4, that's placed on the left side of the terminal connector
allows to reset the installer PIN code to the factory default
(see page 6).
Use this function only in case to forget this code.
With the system switched on, change the jumper position
to reset the code and return it to the standby position.
odule description
M
power supply input.
positif for battery.
negatif for battery.
relay 1 common terminal.
relay 1 output terminal.
relay 2 normally closed output.
relay 2 common terminal.
relay 2 normally closed output.
panic output.
~, ~ :
B+ :
B– :
C1 :
N1 :
NC2 :
C2 :
NA2 :
P :
Reset.
Standby.
