POWER SUPPLY INSTALLATION
2
3
DOOR PANEL INSTALLATION
DIN 46277
f
3,5 x 25
DIN-7971
f
3,5 x 25
DIN-7971
nstalling the TF-104 transformer.
I
To install the transformer directly on the wall,
insert the fixing flanges.
Drill two holes of
Ø6mm. and
insert the wallplugs.
Fix the transformer with the specified
screws.
The transformer can be installed on a DIN guide (3 units) simply pressing it.
To disassemble the transformer from the DIN guide, use a plain screwdriver to lever
the flange as shown on the picture.
The transformer must be installed in a dry and
protected place. It's recommended to protect
the transformer by using a thermo-magnetic
circuit breaker.
1650
1850
1450
mbedding box positioning.
E
The upper part of the module should be placed at 1,65m. height roughly.
The hole dimensions are: 125(W) x 257(H) x 57(D) mm.
The module has been designed to be placed under most of the environmental conditions.
However it's recommended to take additional cautions like rainproof covers.
DOOR PANEL INSTALLATION
Break the bottom flange
to pass the cables through.
reparing the embedding box.
P
Pass the wiring through the hole made in
the bottom part of the embedding box.
Level and flush the embedding box.
Once the embedding box is placed,
remove the protective labels
from the attaching door panel holes.
old the door panel on the embedding box.
H
Select a direction to open the door panel; this selection should ease
the door panel wiring.
The opening direction will be settled through the hinges position,
that must be passed through the header clips as shown.
For example, if the hinges are placed on both clips of the lower
header, the door panel will open downwards; if they are placed
on the right clips of both headers, the door panel will open to left.
To hold the door panel on the embedding box,
insert the hinges in the embedding box lockers
as shown.
