E. REMOVING STIRRER FAN DISK
(Figures 15 and 16)
(1) Remove 1 rivet ASS'Y securing it to the oven
upper plate by using knife blade.
(2) Rotate slightly and pull out the stirrer fan cover.
(3) Remove the stirrer fan disk.
F. REMOVING DOOR (Figure 17)
(1) Remove the vent grille by removing two screws
securing it to the front bracket.
(2) Lift up and push the door.
G. DISASSEMBLING DOOR (Figure 18)
(1) Remove the dielectric choke by using knife
blade or small screw driver, etc.
(2) Remove two screws securing it to the door handle.
CAUTION: Be careful not to damage door seal
plate with the screwdriver.
NOTES:
•
After replacing the door, be sure to check that the
primary interlock switch, the secondary interlock
switch and the interlock monitor switch operate
normally.
•
After replacing the door, check for microwave energy
leakage with a survey meter. Microwave energy
leakage must be below the limit of 5mW/cm
2
. (With a
275 ml water load)
7-9
Door Screen
Figure 16
Figure 15
Figure 18
Figure 17
Summary of Contents for MV-1525B
