GRINDER STRAIGHT HANDLE GH-10-28-O
OPERATION MANUAL
20
The grinding disc must stop.
If the grinding disc does not turn or does not stop, then the function test must be interrupted until the Grinder Straight Handle has
been repaired.
6.3
Operation
A visual inspection is to be carried out before beginning work. In the event of damage, no work may be carried out. Install hydraulic
hoses away from walking and transport routes. Ensure that hydraulic hoses are not installed over sharp edges. Make sure that the
environment is well lit; set up additional work lights if necessary.
6.3.1
Grinding operation
1.
Clean the quick couplings.
2.
Connect the Grinder Straight Handle with the return flow of the hydraulic unit.
3.
Connect the Grinder Straight Handle with the supply flow of the hydraulic unit.
Ensure that the flow and return flow of the hydraulic unit are connected to the correct quick coupling. The hydraulic unit must be
switched off
[JB7]
and without pressure for connection.
Figure 7: Connecting the hydraulic hoses
4.
Start the hydraulic unit.
5.
Hold the Grinder Straight Handle tight with both hands.
6.
Release the locking mechanism and push the operating lever on the handle.
7.
After mounting the new grinding disc let the mounting disc run at full speed for a minute before beginning with grinding.
