42
20. Avoid tight steering angles when towed implements are mounted and the
drive shaft is under strain since the coupling could be damaged.
21. Do not use the 3-point linkage on the lift as a hitch.
22. Regulate the hitch in its lowest possible positions to prevent the machine
from rearing.
23. During transhipments with equipment coupled on the 3-point linkage, tension
the chains and keep the lift raised.
24. The operator must check if
every part of the tractor
and, especially the
safety devices,
are in good working condition and perform to specs. They
should be kept in perform working condition. If you note any defects or
malfunctioning, fix or repair them in good time. If necessary contact your
nearest Goldoni Assistance Centre. Failure to observe these instructions will
release the manufacturer from all liability.
2. CONTROLS AND INSTRUMENT PANEL
See fig.1.
1 Dash.
2 Machine identification plate.
3 Gear lever.
4 Hand throttle.
5 Service brake pedal.
6 Accelerator pedal.
7 Differential lock pedal.
8 Lift control lever.
9 PTO synchronized at 540 Rpm select lever.
10 Parking and emergency brake (depress the pedal and push in the button to
disengage the brake).
11 Seat adjusting lever.
12 Clutch pedal.
13 Steering wheel position adjusting lever.
14 Reduction gear-inverter lever.
15 Choke / engine stop pull knob.
See fig.2
1 Hour counter-Rev counter
2 Red discharge warning light (OFF when engine running).
3 Red oil pressure warning light (OFF when engine running). Only for water
cooled engines.
4 Fuel reserve LED (lights when tank down to about 5.5 liters).
5 Green side lights and low beam headlights indicator light.
6 Blue high beam headlights indicator light
7 Green turn signal indicator light.
8 Oil gauge (for air cooled engines). Temperature gauge (for water cooled
engines).
