9
Display Light
On for 60 sec.
+
>
>
Toggle between Always On and On for 60 sec.
Move to previous/next menu item
This function controls the blue backlight on the display. If the “60 seconds” option is
selected, then the backlight will automatically turn off 60 seconds after the last key is pressed
and will stay off until next time a key is pressed.
Note that the Display Light selection only applies to the display keypad that you are currently
using. Other display/keypads will not be affected. In other words, you need to individually
set this option for each display/keypad in the system.
Teach Wireless:
+ to start
Teach Wireless:
Successful
Teach Wireless:
Failed
Press and hold
wireless button
+
>
>
Push to start process
Move to previous/next settings menu item
Press and hold any button on wireless remote for 4 seconds
>
>
>
>
Move to previous/next settings menu item
Move to previous/next settings menu item
Perform this procedure each time a wireless remote control is added to the Aqua Logic
system. During this procedure the wireless remote “learns” and remembers the ID code for
the wireless base station connected to this particular Aqua Logic unit and will reject mes-
sages with any other ID codes. If “Base NOT found” is displayed, then the Aqua Logic can
not communicate with the transmitter/receiver base station attached to the main unit. If
“Failed” is displayed, then the base station did not receive a signal from the remote control.
This menu will only appear if a wireless base station is connected to the Aqua Logic.
Wireless
Channel: 1
Reteach all
wireless units
Confirm Change:
+ to proceed
+
Push to confirm the channel change
Change the desired wireless channel (1 - 5)
>
>
Move to previous (Teach Wireless) menu
+
>
>
>
>
>
>
If channel is changed, move to confirmation menu
Move to previous/next menu item
If channel is not changed, move to previous/next menu item
This setting changes the channel to be used by the wireless base station and remote(s). If
the channel is changed and confirmed, the wireless remote will have to be re-taught. This
menu will only appear if a wireless base station is connected to the Aqua Logic.
Timers Menu
The Timers Menu allow you to set all timeclock and countdown timers which control the automatic opera-
tion of your pool/spa system.
Each timeclock has a single on/off program per day. All of the timeclocks are setup (Configuration Menu)
either as “all days” or “weekends/weekdays”. If “weekends/weekdays” are selected, you will need to
program on times for both weekdays and weekends and off times for both weekdays and weekends, even
if you want them to be the same. All times are adjusted in 15 minute increments (9:00A, 9:15A, 9:30A,
etc). If you program the on time equal to the off time (“10:00A to 10:00A”) the output will NEVER turn
on. If you want to disable a timeclock, you can set the times equal as noted above or you can adjust the
on time between 11:45P and 12:00A (23:45 and 00:00) and you will notice the times disappear and the
display simply shows “Off”. If, at a later time, you wish to re-activate the timeclock, simply press either the
“+” or “-“ buttons to go back to a normal timeclock programming display.
