Operation
The spa-side remote communicates with the base receiver on the Aqua Logic control
unit using RF (radio frequency) technology. When you push a button on the spa-side
remote, it sends a command and flashes the LED indicator once. After the spa-side
remote receives a confirmation from the Aqua Logic base the receiver, the LED indi-
cator on the spa-side remote flashes a 2
nd
time. Thus, 2 LED flashes are your confir-
mation that your command has been successfully transmitted to the Aqua Logic con-
trol unit. If the LED doesn’t flash at all or else just flashes once after you’ve pushed
a button, refer to the Troubleshooting section for assistance in resolving these prob-
lems.
Valves POOL/SPA
These buttons will allow you to select either pool or spa opera-
tion. You can not select spa spillover operation from the spa-
side remote.
Filter ON/OFF
The ON/OFF buttons allow manual operation that will
override any automatic control settings (e.g. timeclock). The
manual setting will remain active until the next scheduled
automatic turn on/off event. There are some exceptions:
If the heater is operating and the heater cooldown function is
enabled, then pressing the OFF button will turn off the heater
and the pump will run for another 15 minutes to allow the
heater to cooldown before automatically turning off
If the freeze protection feature is enabled and the air tempera-
ture is below 38°F, then the pump will remain on to ensure that
the pipes do not freeze.
2
LDLINE
CONTROLS INC.
G
POOL SPA
ON OFF
ON OFF
ON OFF
ON OFF
ON OFF
VALVES
FILTER
HEATER
LIGHTS
AUX1
AUX2
