14
F.
Installing the BENCH EMITTER PANEL, BENCH PANEL and BENCHES
1. Place the FLOOR EMITTER PANEL onto the FLOOR PANEL. The FLOOR EMITTER PANEL
cord will run under the longer of the two BENCH EMITTER PANELS (to be install shortly) and
plug it into the inlet located on the RIGHT SIDE REAR PANEL at the rear corner of the sauna
room. (see Figure 16)
2. Locate the (2) square wood frames that have two cutouts on one side and a vertical slot on the
other side. Place one of the wood frames next to the glass window with the two cutouts facing the
glass window and the vertical slot facing towards the front. The cutouts fit along the glass window
moldings. The wood frames are
not
interchangeable and so make sure you have them next to the
correct glass window. Do the same with the second wood frame next to the other glass window.
(see Figure 17 and Figure 18)
2. Slide down the BENCH EMITTER PANEL by lining up its sides with the vertical guides on the side
panel and wood frame. The emitter grid will face outward (toward the front of the sauna) and the
cord will be at the bottom of the emitter grid on the inside (between the BENCH EMITTER PANEL
and the REAR PANEL). Push the BENCH EMITTER PANEL all the way down until it is touching
the FLOOR PANEL and is secured in place. Do the same with the shorter bench panel. Make
sure the FLOOR EMITTER PANEL cord fits through the cutout on the bottom of the longer
BENCH EMITTER PANEL.
3. Plug in the left side BENCH EMITTER PANEL cord into the corresponding inlet located on the
LEFT SIDE REAR PANEL. Also plug in the LEFT SIDE PANEL heater cord into the
corresponding inlet on the LEFT SIDE REAR PANEL. Do the same for the right side. (see
Figure 19 and Figure 20).
5. Install the longer of the two BENCHES first by tilting the end at the LEFT SIDE REAR PANEL
and carefully guiding the other end downward and into position. Then slide the shorter of the two
BENCHES into its position. Push the BENCHES all the way in until they touch the REAR
PANELS and are secured in place. Make sure to install the BENCHES with the smooth and
finished sides facing up and the predrilled holes at the rear. It is optional if you would like to
mount the benches using the provided screws. (see Figure 21)
Figure 16
Figure 17
