6
In arming mode, if the transmitter is lost or damaged, you can disarm the system by opening the door with your
original car key. The system is triggered and alarming at the same time, siren keeps chirping and turn signals
keep flashing. And then turn the car key from ON to OFF continuously for 5 times, the system will be override.
Or you can buy a matched transmitter, disarm the car by phone and then learn the new transmitter into the
system.
11. Selection of Power Lock and Pneumatic Lock
Power Lock is set in factory before delivery. The installer should open the casing of the main unit to select
Pneumatic Lock.
12. Closing Windows Signal Output
In arming mode, when press
or
to arm, the system will send a signal to close the windows. If the car is
installed with power windows, the windows will be closed within 25 sec.
13. Triggered Alarm Memory
In arming mode, if the arming zones are triggered and alarming, when the car is disarmed, siren will chirp, LED
and turn signals will flash in different ways to warn.
Triggered Zone
Arming Mode
Disarming Mode
Shock sensor is alarming
LED flashes twice
Siren chirps 3 times, turn signals flash 3 times,
LED flashes 3 times
Any door is opened by force
LED flashes twice
Siren chirps 4 times, turn signals flash 4 times,
LED flashes 4 times
Ignition is triggered illegally
LED flashes twice
Siren chirps 5 times, turn signals flash 5 times,
LED flashes 5 times
When any door is opened after disarming, siren will chirp once again to warn.
PHONE GSM USING GUIDE
FMG031 car alarm system is equipped with a GSM module inside the main unit. It realizes the function of controlling the car alarm
system and protecting the car by mobile/fixed phone.And it means that the control range is not limited as long as the GSM
network is available. Let’s see how to make it work as below:
Firstly, after the installation is finished and before the power is connected, put an available mobile phone SIM card inside the main
unit and make sure the GPRS of this SIM card is available too (to ensure the GPS PC tracking function will be successful).
Secondly, after putting the SIM card well, connect the power and use the user’s mobile phone to call the phone number of the
main unit’s SIM card to check whether it can be gotten through or not. If it cannot be gotten through, cut off the power and take
away the back up battery, check whether the GSM antenna is attached well or whether the SIM card inside the main unit is placed
well.After checking everything well, repeat a phone call until the SIM card inside the main unit is gotten through.
▶ ▷
Phone Using Guide:
Pls use the mobile phone/ fixed phone to send SMS or call the main unit’s SIM card to control the car alarm system. Methods are
as following:
▶
by SMS ---- if you use the 2 supervisor phones to control, you just need to send the operation code of 3 digits
plus # to the SIM card inside the main unit (just like to send a SMS to the other mobile phone); if you
use other mobile phones including 3 spare phones to control, you need to send the operation
password and the operation code together (plus #) to the SIM card inside the system (for example:
to arm the car, the operation password is 123456, the operation code is 001, the content of SMS
should be 123456001#). The system will send a SMS response the 1
st
supervisor phone to confirm
the successful operation. There will be no voice response.
▶
by PHONE CALL ---- if you use the 2 supervisor phones to control, after getting through the SIM card inside the
