21
LIGHTING INSTRUCTIONS ELEC. SPARK TO PILOT
1. “STOP” Read the safety information on
page 11.
2. Set the switch to “OFF”.
3. Remove batteries from battery pack.
4. This appliance is equipped with an ignition
device which automatically lights the burner.
Do not try to light the burner by hand.
5. Wait (5) minutes to clear out any gas. Then
smell for gas, including near rgw floor. If you
smell gas, STOP! Follow “B” in the safety
information on page 13. If you don’t smell
gas, go to next step.
6. Install (2) D batteries in battery pack.
7. Turn ON/OFF rocker switch to “ON”.
8. If the appliance will not operate, follow the
instructions “To turn Off Gas To Appliance”
and call your service technician or gas supplier.
NOTE: DAMPER CONTROL LEVER MUST
BE IN THE “OPEN” POSITION TO IGNITE.
GaS ValVe
TO TURN OFF GAS TO APPLIANCE
1. Turn ON/OFF rocker switch to “OFF”
2. Remove batteries from appliance if service is to be performed.
LPG (PROPANE) WARNING
THE FOLLOWING WARNING APPLIES TO INSTALLATIONS USING L.P. (PROPANE GAS):
WARNING: To avoid possible injury, fire and explosion, please read and follow these precautions
and all instructions of this appliance before operating. This appliance uses L.P. (Propane)
gas which is heavier than air and will remain at the floor level is there is a leak. Before lighting,
smell at floor level and/or use other means (such as using a soap solution on all piping and
connections, using a gas detector, etc.) to check for gas leaks. NOTE: L.P. (Propane) gas can
become odorless and CANNOT always be detected by smell. If you smell gas, detect a gas leak or
suspect that a gas leak exists, follow these rules:
1. Get all people out of building.
2. DO NOT light matches. DO NOT turn electric lights or switches on or off in area. DO NOT use
an electric fan to remove gas from area. DO NOT use a telephone inside of building.
3. Shut off gas at L.P. tank outside of building.
4. Telephone gas company and fire department. Ask instructions. Before hanging up, give your
name, address and phone number. DO NOT go back into building.
If your L.P. tank runs out of fuel, turn off gas at the appliance. After L.P. tank Is refilled, appliance
must be re-lit according to manufacturer’s instructions. If The gas control has been exposed to
WATER in any way, DO NOT try to use it. It must be replaced. DO NOT attempt repair on gas
control or appliance.
Tampering is DANGEROUS and voids all warranties. Any component that is found to be faulty,
must be replaced with an approved component.
TO TURN OFF GAS TO APPLIANCE
