
At the top of the screen you will see
a memory strip indicating the most
recent device set up (i e that was
used on the previous locating job)
At this time you may either
continue to locate with the stored
settings (RESUME) or opt for new
settings (NEW SET UP) Notice that
a small timer icon appears in the
upper right corner of the screen
When this graphic “times out” any
active menu will be removed from
the screen and the receiver will
return to its original operating
settings
To RESUME:
Verify that the
icon is pointing at “RESUME” in the
startup menu then CLICK HOLD The receiver is now ready
to locate (NOTE: the
icon will always point at
“RESUME” at startup making it very easy to continue with
an ongoing job )
NEW SET UP:
To opt for new settings CLICK to advance the
icon to
“NEW SET UP” then CLICK HOLD The display will then
immediately present the “Set Frequency” screen shown
below
SETTING THE FREQUENCY
As the menu graphic to the right
indicates there are three different ways
to set the receiver’s locating frequency:
by scanning for it by selecting it from a
catalog or by selecting the “passive”
mode
Setting Frequency by Scanning
Using the “BY SCAN” Option will
automatically tune the
Receiver to
the exact frequency of the transmitting
source (i e Model
X Transmitter
another active line energizer a “sonde”
or a camera head) To do this hold the receiver with the pointer antenna
aimed directly at the active transmitting source and held about to feet
away from it CLICK the
icon to point to “BY SCAN” and then CLICK
HOLD
You will see the word “SCANNING” flashing
on the screen while the receiver scans for
the active transmitter If SCAN fails to
detect anything you will here a low pitched
tone and the
will return to its previous
operating mode