Operating your Micathermic Heater
SUPPORT AND TECHNICAL ADVICE
PO Box 100707, NSMC, Auckland, New Zealand
Monday
– Friday 8am-5pm
Phone: 0800 232 633
Website: www.Goldair.co.nz
CARE AND CLEANING
The heater requires regular cleaning to ensure
trouble free operation:
Unplug the heater from the mains supply before
cleaning.
Ensure that the heater has been allowed to cool
down completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of
the heater to remove dust and dirt.
Never use solutions such as benzene, thinners or
polishing agents. In order to get the maximum heat,
the reflector must be kept clean.
Use a vacuum cleaner to remove dust and fluff from
around the grills.
Ensure the heater is dry before plugging back into
the mains supply.
Do not attempt to dismantle the Micathermic Heater.
There are no user serviceable parts. For service or
repair, contact an authorised electrical service
technician.
CAUTION
The Micathermic Heater generates heat during use.
Proper precautions must be taken to prevent the risk
of
burns, scalds, fires or other damage to persons
.
Do not use this heater with a programmer, timer,
separate remote-control system or any other device
that switches the heater on automatically.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase. (Refer to back of booklet).
IMPORTANT! NEVER COVER THIS HEATER!
WARNING Keep all objects at least 1 metre
from the front, sides and rear of the
appliance.
HEAT CONTROL SWITCH
The control switch positions are:
0 OFF
I Low Heat
II High Heat
Check that the heat control switch is set to off
position before plugging the heater into the
mains supply. For greater economy, use the
high heat setting initially and then switch to
the low heat setting.
THERMOSTAT
Turn the thermostat knob clockwise until the
maximum temperature is obtained on the
graduated
scale.
When
the
desired
temperature is reached, slowly turn the knob
anti-clockwise until the heater turns off (you
will hear a click). The heater will now cycle on
and off to maintain the set temperature.
Note: When the heater is turned on for the
first time, it may release a slight, odour or
smoke. This odour or smoke is a normal
occurrence caused by the initial heating of the
internal heating elements and should not
occur again.
SAFETY DEVICE
This appliance has two protection devices:
The first device, automatically disconnects &
reconnects the appliance at a pre-set
temperature.
The second device disconnects the appliance
permanently in case of overheating, by means
of a thermal fuse. (It is non resettable)
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the
unit before use. This appliance requires no installation, it should be used
solely as a portable appliance.
Summary of Contents for Select GSMH100
Page 1: ...Operating Instructions Micathermic Heater Model GSMH100 ...
Page 2: ......
Page 8: ......