TECHNICAL SPECIFICATION
Model No:
GPH100
Supply:
220-240VAC 50Hz
Wattage:
1000W
Operating Your Heater
SAFETY DEVICES
This appliance has two protection devices:
•
Resettable Thermal Link - this will automatically disconnect the power to the
appliance at a pre-set overheat temperature. After cooling down it will reset and
power on again. If this occurs, investigate what is causing the appliance to overheat.
•
Thermal Fuse - this disconnects the appliance permanently in case of overheating. (It
is non resettable).
Note: The light in the power switch will remain on even after the safety devices have
activated to show there is still power to the heater
CAUTION:
The heater generates heat during use. Proper precautions must
be taken to prevent the risk of burns, scalds, fires or other damage to persons.
CARE AND CLEANING
•
The heater requires regular cleaning to ensure trouble free operation:
•
Unplug the heater from the mains supply before cleaning.
•
Ensure that the heater has been allowed to cool down completely before cleaning.
•
The common cause of overheating is deposits of dust or fluff in the appliance. Ensure
these deposits are removed regularly by unplugging the appliance and vacuum
cleaning the air vents and grills.
•
Use a damp cloth (not wet) to wipe the exterior of the heater to remove dust and
dirt.
•
Never use solutions such as petrol, thinners or polishing agents.
•
Ensure the heater is dry before plugging back into the mains supply.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of purchase.
SUPPORT AND TECHNICAL ADVICE
Goldair
–
New Zealand
Monday
–
Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
[email protected]
Goldair
–
Australia
Monday
–
Friday 8am-5pm
Phone +61 (0)3 9365 5100
Phone 1300 465 324
