Operating your Micathermic Heater
Always choose a safe location for the heater, keeping in mind the safety precautions
outlined. Ensure all packaging has been removed from the unit before use. This
appliance requires no installation, it should be used solely as a portable appliance.
WARNING: THIS IS A DOUBLE SIDED HEATER.
Keep all objects at least 1 metre from the front,
sides and rear of the appliance.
WARNING: In order to avoid overheating, do
not cover the heater.
WARNING: Never leave this heater unattended.
WARNING: Do not use this heater with a
programmer, remote-control system, separate
timer or any other device that switches the heater
on automatically.
POWER SWITCH
Check that the heat control switch is set to Off
position before plugging the heater into the mains
supply.
CONTROL PANEL
Press the Power button to switch the appliance ON.
The digital display will show the room current room
temperature.
The “-”and “+” buttons can be used to select High
heat or Low heat. This is indicated by the
segments on the right corner of the screen:
1 Light = Low Heat
2 Light = High Heat
Note: When the heater is turned on for the first
time, it may release a slight, odour or smoke.
This odour or smoke is a normal occurrence
caused by the initial heating of the internal
heating elements and should not occur again.
TIMER
Press the Timer button then use the “+” or “-” buttons
to adjust the length of time from 1 – 18hours that you
would like the heater to run for before turning off.
Each press of the “+” or “-” button will adjust the
length of time by 30 minute increments.
To turn off the Timer function, set the Timer back to
“0” hours or simply turn the unit off.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase. (Refer to back of booklet).
THERMOSTAT
Press the TEMPERATURE button, then use the “-” or
“+” buttons to set the target temperature. The
thermometer symbol will illuminate, and the digital
display will flash, showing the target temperature.
After 5 seconds the display will stop flashing and
return to displaying the room temperature.
SAFETY DEVICE
This appliance has three protection devices:
The first device will automatically turn the appliance off
if the appliance is not in the appropriate operating
position.
The second device automatically disconnects &
reconnects power to the appliance at a pre-set
temperature.
The third device disconnects the appliance
permanently in case of overheating, power spike or
product damage, by means of a thermal fuse (It is non
resettable).
CARE AND CLEANING
The heater requires regular cleaning to ensure
trouble free operation:
Unplug the heater from the mains supply before
cleaning.
Ensure that the heater has been allowed to cool
down completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of
the heater to remove dust and dirt.
Never use solutions such as benzene, thinners or
polishing agents.
Use a vacuum cleaner to remove dust and fluff
from around the grills.
Ensure the heater is dry before plugging back into
the mains supply.
Do not attempt to dismantle the Micathermic
Heater. There are no user serviceable parts. For
service or repair, contact an authorised electrical
service technician.
CAUTION
The Micathermic Heater generates heat during
use. Proper precautions must be taken to prevent
the risk
of
burns, scalds, fires or other damage to
persons
.
SUPPORT AND TECHNICAL ADVICE
Goldair – New Zealand
Monday – Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
[email protected]
Goldair – Australia
Monday – Friday 8am-5pm
Phone +61 (0)3 9365 5100
Phone 1300 465 324
