GENERAL NOTES
This Goldair product is designed only to be used as a fixed Heat/Light/Vent product, installed into the
ceiling. If the product is installed or used for any other purpose the warranty will be void.
Installation of this product must be completed by a registered electrician.
Handle product with care, remove the bulbs during installation.
The unit must be located and installed in accordance with the AS/NZS 3000:2007 and any local
regulation information for mounting in damp areas (please consult your local electrician for
information).
The unit can be installed in any room that requires direct radiant heating and circulated air flow such as
bathrooms, ensuites, laundries, etc.
The unit must be installed in flat ceilings with a minimum height of 2 metres from the floor.
Do not install the unit directly above shower or bath recesses or enclosures.
The unit must not be installed in a position where water may splash onto the heat lamps.
At least 220mm height clearance in the ceiling cavity is required to ensure sufficient ventilation for
moisture to disperse.
The unit must also be installed at least 400mm away from the walls.
For maximum efficiency to remove steam and odours, there must be an adequate air flow within the
room. To obtain maximum air flow ensure there is a gap under doors or open windows slightly. A good
test for this is that the fan should not change speed (or sound) when you close or open the bathroom
door.
The unit can be connected to a lighting or power circuit if loading permits. All electrical work must be
carried out by a registered electrician in accordance with AS/NZS 3000:2007 (please consult your local
electrician for information). A three gang switch is included to so the user can independently switch the
Ventilation, Heat and Light on and off. This needs to be installed in a position where it cannot be
reached from the bath or shower.
Heat lamps and light bulbs supplied with the unit are test bulbs only, these are not covered under the
product warranty.
HEAT/LIGHT/VENT INSTRUCTIONS
