HEAT CONTROL SWITCH
The control switch positions are:
0 = OFF
I = Low Heat
II = High Heat
= Fan
Check that the heat control switch is set to the off
position before plugging the heater into the mains
supply. For greater economy, use the high heat
setting initially and then switch to the low heat
setting.
For the Low (I) and High (II) heat settings the fan
speed remains the same; only the heating block
changes to create the greater/lesser heat output.
THERMOSTAT
Turn the thermostat knob until the maximum
temperature is obtained on the graduated scale.
When the desired temperature is reached, slowly
turn the knob anti-clockwise until the heater turns
off (you will hear a click). The temperature will now
remain constant, regulated by the thermostat.
TECHNICAL SPECIFICATIONS
Model No: GCH250B, GCH250R, GCH250W
Voltage 220-240V AC
Frequency 50Hz
Wattage 1500W
CARE AND CLEANING
The heater requires regular cleaning to ensure
trouble free operation:
Unplug the heater from the mains supply before
cleaning.
Ensure that the heater has been allowed to cool
down completely before cleaning. Use a damp
cloth (not wet) to wipe the exterior of the heater to
remove dust and dirt. Never use solutions such as
benzene, thinners or polishing agents. In order to
get the maximum heat, the reflector must be kept
clean. Use a vacuum cleaner to remove dust and
fluff from around the grills. Ensure the heater is dry
before plugging back into the mains supply.
Do not attempt to dismantle the Ceramic Heater.
There are no user serviceable parts. For service or
repair, contact an authorised electrical service
technician.
SUPPORT AND TECHNICAL ADVICE
PO Box 100707, NSMC, Auckland, New Zealand
Monday
– Friday 8am-5pm
Phone: 0800 232 633
Website: www.goldair.co.nz
Operating your Ceramic Heater
Always choose a safe location for the heater, keeping in mind the safety precautions
outlined. Ensure all packaging has been removed from the unit before use. This appliance
requires no installation, it should be used solely as a portable appliance.
WARNING Keep all objects at least 1 metre
from the front, sides and rear of the appliance.
SAFETY DEVICE
This appliance has three protection devices:
The first device will automatically turn the
appliance off if the appliance is not in the
appropriate operating position.
The second device, automatically disconnects &
reconnects the appliance at a preset temperature.
The third device disconnects the appliance
permanently in case of overheating, by means of a
thermal fuse (It is non resettable).
CAUTION
The Ceramic Heater generates heat during use.
Proper precautions must be taken to prevent the
risk of burns, scalds, fires or other damage to
persons.
Do not use this heater with a programmer, timer,
separate remote-control system or any other
device that switches the heater on automatically,
since a fire risk exists if the heater is covered or
positioned incorrectly.
IMPORTANT! NEVER COVER THIS HEATER!
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase.