13
The detector responds with a signal when it detects most
valuable metal objects. If a signal does not repeat after you
sweep the search coil over the target a few times, the target is
probably junk metal.
False signals can be caused by trashy ground, electrical
interference, or large irregular piece of junk metal.
False signals are usually broken or non-repeatable.
Adjusting SENSITIVITY
After you become familiar with how your detector works, it’s
important to fine tune the sensitivity to get a good effect.
Press the touch button SENS on the panel. Then press UP or Dn
to
increase or decrease the sensitivity. The level on the segment will
be displayed from high to low position.
Note:
In order to detect the target deeply buried, you can adjust the SENS
to a high position. But not to set the level of SENS to Max position,
or the detector will receive interference and false signal from
broadcast antenna and other electronic lines. The detector will have
unstable arrow and irregular tone indications.
Application Hints
Pinpointing The Target
Accurately pinpointing a target makes digging it up easier. But it takes
practice. We suggest you practice finding sample on your own property
before you search other locations.
Follow these steps to pinpoint a target.
1. When the detector detects a buried target, continue sweeping the
search coil over the target in a narrowing side-to-side motion.
