10
Controlling the Source Device
1.
Connect an IR Blaster Extension Cable to the IR Out
port of the HDBaseT Extender/Splitter.
2.
Point the IR Blaster Extension Cable's IR eye in line
with the source device's IR window.
3.
Connect an IR Receiver Extension Cable to the IR In
port on each HDBaseT Receiver.
Figure 6: Source Device IR Control Connection Diagram
Note:
The IR ALL IN / IR LOOP IN will relay the received IR
signal to all the HDBaseT outputs whereas the IR IN
connectors associated with each HDBaseT output will
only relay the IR signal to its respective receiver. The IR
LOOP IN can also be connected to the IR LOOP OUT of
another Extender/Splitter when two or more units (up to
a maximum of five) are connected in a cascade mode
while using only a single IR detector at the start of the
cascade connection.
The IR OUT connector will output the IR signals received
from any of the HDBaseT receivers, so as to allow control
of a source from any of the remote receivers.
