Setting the Transmitter
group’s setting turns to the maximum(1/1) or the minimum(Min.). If the current group
is in the TTL mode, all the other groups which are in the M mode will change their
FEC amount simultaneously. The FEC amount is changeable from -3 to 3 in 0.3 stop
increments, until one of the group’s setting turns to the maximum(3) or the minimum(-
3). If the current group is in the -- mode (flash off), the amounts will not change.
4. Short press the <GR> Button again to confirm the setting.
Test Flash
1. Press the <TEST> Trigger Button to see the
whether flash will fire normally or not.
2. Fully press the <TEST> Trigger Button, and
the Status Indicator Lamp turns red and the
flash can be triggered.
3. The settings on the transmitter end will
synchronize to the receiver end at the same
time.
Modeling Lamp Control
Double-click the <CH
/
OK> Button to power ON/OFF the modeling lamp.
- 33 -
- 34 -
Setting the Transmitter
Automatically Enter Power Saving Mode
1. The flash trigger will go into standby mode after the transmitter enter sleep mode, and
the displays on the LCD panel will disappear.
2. Press any of the button (<TEST> fully pressed/<CH
/
OK>/<GR>/<MODE>) can wake
up the flash trigger. If the transmitter is attached to the Olympus or Panasonic
camera, half press the shutter can also wake up the system.
3. If the transmitter is set to single contact mode( is displayed), the system will not
enter power saving mode.
The following table lists the available and unavailable custom functions of this flash.
Note: Some icons will be displayed when setting the relevant custom functions to make users
have a good understanding.
Functions
Synchronization
delay setting
Single contact
mode
Custom
Functions No.
C.Fn-00
C.Fn-01
Settings and Description
OFF
Master flash synchronization delay N*100 us
(synchronization delay icon
is displayed.)
OFF
ON (The single contact mode set icon
is displayed.)
It is advisable to set the transmitter to single contact
mode when using it to trigger the flash by PC cord or
through camera's single contact.
Setting Signs
00
1~100
--
on
C.Fn: Setting Custom Functions