
Setting the Transmitter
Slide the Power Switch to ON, and the device is on and Status Indicator Lamp will not
blink.
Note: In order to avoid power consumption, turn off the transmitter when not in use.
Power Switch
Slide the switch to ON or OFF to control the HSS high-speed sync's on or off.
If is ON, the group's mode setting icon will keep blinking.
HSS High-speed Sync Switch
Channel Settings
1. Short press the <CH
/
OK> Button until the
channel amount blinks.
2. Turn the Select Dial to choose the
appropriate channel. Press the <CH
/
OK>
Button again to confirm the setting.
3. This flash trigger contains 32 channels which
can be changed from 1 to 32. Set the
transmitter and the receiver to the same
channel before usage.
CH
- 29 -
- 30 -
Setting the Transmitter
Mode Settings
1. Short press the <GR> Button and the
selected group will blink. Click to choose
downwardly and double-click to choose
upwardly.
2. Short press the <MODE> Button and the
selected groups' modes will be changed by
the order of TTL/M/--(-- represents OFF,
which means that the current group will not
fire flashes in this mode).
Group POWER / FEC Settings
1. Short press the <GR> Button and the
selected group will blink. Click to choose
downwardly and double-click to choose
upwardly.
2. Turn the Select Dial to change the power or
flash exposure compensation settings.
When the current group is in the M mode, the
power output value is changeable from
1/1 full power to Min. [Note 1] power in 0.3 stop increments. When the current group is
in the TTL mode, the FEC amount is changeable from -3 to 3 in 0.3 stop increments.
When the current group is in the -- mode (flash off), the amounts will not change.
3. Short press the <CH
/
OK> Button again to confirm the setting.
CH
CH