ENG
ENG - 42
Clean the main brushes of the Cleaner
Turn off the power switch and put the Cleaner on flat surface with its bottom up.
Use cross head screwdriver to remove the fixing screw on the right, and then take out the
main brush, rubber brush and brush coupler together as shown in the following drawing.
Clean the chamber where the brush is located and the contaminants on brush and rubber
brush.
Wipe out dirt on the metal shaft and bearing of the brush coupler and the brushes (this may
not be necessary to do after every cleaning) as per following drawings. If necessary, you
may add a little lubricant to it.
Put the brush coupler and brushes back and tighten the screw.
1)
2)
3)
4)
5)
Summary of Contents for CL 490
Page 49: ...Poznámky Notes ...
Page 50: ...Poznámky Notes ...
Page 51: ...Poznámky Notes ...
Page 52: ......
