Goddess CL 490, Instruction Manual

Page: 40 / 52

ENG
ENG - 40
Use the infrared remote controller by referring to the following drawing:
T1 Spot key
T2 Power key
T3 Clean key
T4 Indicator
T5 Max key
T6 Direction key
The cleaner can be controlled to clean by the infrared remote controller. As the above drawing,
three keys: Spot, Clean and Max is respectively for three work modes. By direction key, it can
operate the Cleaner to work in different directions. The P key is for powering on/off. Press the
P key, the indicator on the panel will be off and the Cleaner enter Sleep mode, which enable to
save energy maximally in non-operating state. Press again the P key on the panel, the indicator
will be on, and the unit will enter the Standby stage, waiting for the next command.
When the Virtual Wall and remote controller are used in the same area, as they all use the infra -
red signal, which may lead to temporary failure for the remote controller, you may operate
the remote controller after turning off the Virtual Wall or the unit being far from the Virtual Wall.
Intelligent cleaner is user-friendly very little maintenance required after use to ensure optimal
performance please observe the following procedures: