2
Socket Head Cap
Screw M2.5x12mm
(HC026-S)
13-15mm
SERVO ASSEMBLY 1, 2, 3
Servo 1
Socket Head Cap
Screw M2.5x6mm
(HC018-S)
Uniball M2
(H0538-S)
INSTALLATION OF SWASHPLATE SERVOS
The linkage ball must be positioned approximately
13-15 mm
out on the servo arm (
figure 1
), it is recommended to use the SAB
servo arm p/n [HA052]. Because of the 120° placement of the servos in the Goblin, the arms are difficult to access. For this reason
it is advisable to ensure alignment of the servo arms (and sub trim) before installation of the servos in the model
(figure 2)
.
Proceed with installation following the instructions below
. Figure 3
shows a completed installation.
The rods going from the servos to the swash plate must be as vertical as possible. ( Red line in Figure 4 )
Not all servos are equal, so for proper alignment you can choose to use the supplied
spacer H0566 under the uniball H0538.
Bag 6
Servo 2
Servo Spacer
(H0075-S)
Servo 2
Button Head Cap
Screw M2x5mm
(HC005-S)
SAB Servo Arm
(HA052-S) ( Option)
Servo 3
Button Head Cap
Screw M2x5mm
(HC005-S)
Note:
Do not over tighten,
be careful to not strip plastic.
Note:
Do not over tighten,
be careful to not strip plastic.
Page 11
Chapter 8, Installation Of Swashplate Servos
