10
REV.01
INSTALLATION INSTRUCTIONS
© 2016 Go Rhino Products. All rights reserved
Step-6 Align the holes in the side rails with the rivet-nuts installed in the front base then attach each
side rail to the front base using (2) ¼” x ¾” button head screws and (2) ¼” plastic flat washers, (Fig 8
& 9). Snug but do not tighten the screws.
Step-7 Remove the paper backing and apply a strip of foam tape to the face of the front base as shown,
(Fig 8 & 9). Repeat Step 6 and 7 to attach the side rails to the rear base, and apply the foam tape.
C-H
5
4
Fig 8
Fig 9
5934048T Shown
J
