Original Instruction Manual
En
.
To assembly the disc, press the spindle-lock button in deep and
hold it in this position continuously. If necessary, turn the spindle
slightly with the free hand until it locks into position.
And then put the disc between two parts of flange and then tighten it
with the spanner provided.
Flange arrangements
Vibrating discs must be replaced immediately.
Please always keep other persons and combustible material from work area.
Please always make sure work with guard and disc in position before start the
machine.
Removing disc
To remove the disc, press the spindle-lock button in deep and hold it in this position
continuously. If necessary, turn the spindle slightly with the free hand until it locks into
position.
Loose the flange with the spanner provided and then remove the disc from spindle.
CAUTION!
Check the diameter of disc regularly during use. If it is less than 80mm, replace it!
On/Off switch
The machine can only be started by depressing the on/off switch first, by pressing rear
part of the switch, to prevent any unintentional operation.
The On/Off switch can locked in ON position for continuous grinding: Press down the
front part of the switch
To release the on/off switch, in this position, press rear part of the switch this will
release the switch to off position.
Remark
: Machines with a lockable switch are supplied with a restart cutout. This
prevents the machine restarting by itself after a power failure. When resuming work,
10
01/2017
