Original Instruction Manual
En
SAFETY WARNINGS SPECIFIC FOR GRINDING OPERATIONS
a)
This power tool is intended to function as a grinder. Read all safety
warnings, instructions, illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below may result in electric
shock, fire and/or serious injury.
b)
Operations such as wire sanding, wire brushing, polishing or cutting-off are
not recommended to be performed with this power tool. Operations for which
the power tool was not designed may create a hazard and cause personal injury.
c)
Do not use accessories which are not specifically designed and
recommended by the tool manufacturer. Just because the accessory can be
attached to your power tool, it does not assure safe operation
.
d)
The rated speed of the accessory must be at least equal to the maximum
speed marked on the power tool. Accessories running faster than their rated
speed can break and fly apart.
e)
The outside diameter and the thickness of your accessory must be within
the capacity rating of your power tool. Incorrectly sized accessories cannot be
adequately guarded or controlled.
f)
Threated mounting of accessories must match the grinder spindle thread.
For accessories mounted by flanges, the arbour hole of the accessory must
fit the locating diameter of the flange.
Accessories that do not match the
mounting hardware of the power tool will run out of balance, vibrate excessively
and may cause loss of control.
g)
Do not use a damaged accessory. Before each use inspect the accessory
such as abrasive wheels for chips and cracks, backing pad for cracks, tear
or excess wear for loose or cracked wires. If power tool or accessory is
dropped, inspect for damage or install an undamaged accessory. After
inspecting and installing an accessory, position yourself and bystanders
away from the plane of the rotating accessory and run the power tool at
maximum no-load speed for one minute. Damaged accessories will normally
break apart during this test time.
h)
Wear personal protective equipment. Depending on application, use face
shield, safety goggles or safety glasses. As appropriate, wear dust mask,
hearing protectors, gloves and workshop apron capable of stopping small
abrasive or workpiece fragments. The eye protection must be capable of
stopping flying debris generated by various operations. The dust mask or
respirator must be capable of filtrating particles generated by your operation.
Prolonged exposure to high intensity noise may cause hearing loss.
i)
Keep bystanders a safe distance away from work area. Anyone entering the
work area must wear personal protective equipment. Fragments of workpiece
or of a broken accessory may fly away and cause injury beyond immediate area of
operation
.
j)
Hold the power tool by insulated gripping surfaces only, when performing
an operation where the cutting accessory may contact hidden wiring or its
own cord. Cutting accessory contacting a "live" wire may make exposed metal
parts of the power tool "live" and could give the operator an electric shock.
k)
Position the cord clear of the spinning accessory. If you lose control, the cord
5
01/2017
