BB005x Installation and Configuration Guide
You have now successfully configured your Gnet BB005x modem/router.
Please turn off the BB005x power, wait 5 seconds and then turn it back on.
To complete the installation process and to ensure that your network
card properties settings are correct, please go through the following
steps:
►
1. Connect the RJ-11 phone cable to your modem.
2. Close your web browser.
3. Proceed to confirm or change, if necessary, the settings of the network
card on your computer using the procedures described the Change the
settings of your computer: Procedure B for Windows 95/98/ME or
Procedure D for Windows 2000/XP
If you have configured your Gnet BB005x for RFC 2516 Routed (PPPoE) mode,
please continue with the following steps:
Windows 95/98/ME:
1. Close all programs.
2. Click on the Start button.
3. Click on Run and in the Open field enter:
winipcfg
4. Under Ethernet Adapter Information, use the drop down menu to select your
network card (Example: Realtek 8139-series PCI NIC).
5. Click on the Release button and wait for about 5 seconds.
6. Click on the Renew button.
7. Close the Winipcfg program.
You have completed the configuration and installation process for the RFC 2516
Routed (PPPoE) mode and you can start accessing the Internet by launching
your browser.
Windows 2000/XP:
1. Close all programs.
2. Click on the Start button.
3. Click on Run and in the Open field enter:
cmd
4. From the prompt, type in
ipconfig/release
and then press the Enter/Return
key.
5. From the prompt, type in
ipconfig/renew
and then press the Enter/Return
key.
6. From the prompt, type in
exit
and then press the Enter/Return key.
You have completed the configuration and installation process for the RFC 2516
Routed (PPPoE) mode and you can start accessing the Internet by launching
your browser.
The figure below shows a typical RFC 2516 routing configuration with 2
computers on the Ethernet interface of the BB0055 forming a Local Area
Network with private IP addresses assigned by the DHCP server inside the
36
