BB005x Installation and Configuration Guide
23. Click on the
Save
button. Please wait until the Save operation has been
completed (this may take up to one minute).
After the Save operation has been completed you will see the following screen:
You have now successfully configured your Gnet BB005x. Please turn the
BB005x power off, wait 5 seconds and then turn it back on.
►
To complete the installation process and to ensure that your network
card properties settings are correct, please go through the following
steps.
1. Connect the RJ-11 phone cable to your modem.
2. Close your web browser.
3. Close all programs.
4. Proceed to confirm or change, if necessary, the settings of the network
card on your computer by following the procedures described in the
Changing your computer settings section: Procedure B for Windows
95/98/ME or Procedure D for Windows 2000/XP.
You are now ready to connect to the Internet using a PPPoE software client
(Enternet 300 or RASP PPPoE) provided by your ISP or by connecting the
BB005x to a firewall/gateway/router device that will initiate the PPPoE
connection. The RFC 1483 bridging configuration where the computer needs to
run a PPPoE software client is shown in the figure below.
26
