HOW TO LAMINATE
3rd Step : Lamination
☞ Test Lamination : When the temperature of the roller reaches the Set temperature, do a test lamination to check the status.
A low speed lamination is recommended for test lamination and please follow the below instrutions
1. Decurling : Please control the curves fo the papers with DECURLING ADJUSTABLE KNOB, Please refer Main device section as reference.
2. Lamination : Set temperature and laminating speed depend on the laminating quality.
☞ Lamination : If the result of test lamination is okay, increase the speed and proceeed with lamination
Warning :
Ensure all hair, neckties, necklaces, are kept free from the feeding table to avoid injury.
※ This machine contains special speed and temperature control program to improve lamination quality.
1. Soft Accelerate System
- This program is to apply the change of the job speed within 20secs if the job speed is rapidly increased.
This delays the temperature decrease caused by the high speed rotation to prevent the low temperature that causes deterioration of laminating quality
2. Temperature control program
- the heater would be linked with speed to compensate the heat of the roller faster while the roller is on the job.
Start
(Speed 3)
KEY IN
(SPEED 6)
20sec
20sec
20sec
Example)
Starting job with a speed of 3 and increase the speed to 6
①
The speed message will blink while changing the speed
②
The message will no longer blink when the speed reaches
the set speed.
Remarks :
If the temperature of the roller is lower than the set temperature while increasing the speed,
the speed will not increase from that point and "L-TEMP" message will appear on the display. This
message will be disappeared when the compensation of the temperature is made. Please increase the
speed again after the "
L-TEMP
" message disappears.
17/25
