HOW TO USE CONTROL PANEL
C & D. Temperature set button (TEMP) : This is to set roller temperature. Temperature setting range is
"0 ~ 150"℃.
TOP TEMP : temperature setting button for upper roller, BOTTOM TEMP : temperature setting button for lower roller
☞ Temperature setting : after pressing "TOP" or "BOTTOM" button, adjust temperature by rotating MASTER DIAL
E. Roller run/stop button : To stop or run roller.
t
When pressing "RUN" button, roller is pressurised and run at the speed set. When pressing "STOP" button, roller is released & stop.
Ref. : If roller starts running at extremely high speed in the state of STOP, problem may happen.
e
F. Button for roller reverse running
: To make roller run reversely
When roller is pressurized ("RUN" or "PRESSURE PRESS"), during the time of pressing "REV" button, roller runs reversely,
The numbers on display window for speed flicker and beep sound comes. Use this only for roller cleaning or when problem happens.
G. Button for roller pressurization/release
Button for roller pressurizing or releasing. Use this function for roller reverse running or when installing film at the beginning of job.
H. Button for selecting printer IN LINE/OFF LINE
Button for selecting function of connecting printer, IN LINE type or OFF LINE type.
I. Button for setting speed : To set laminating speed. Speed setting range is
"1 ~ 9".
☞ Speed setting : After pressing "SPEED" button, adjust speed by rotating MASTER DIAL.
J. Button for selecting job mode
"JOB" button is to save job condition(Temperature) user set very frequently for lamination.
13 different kind of job condition (1~9, H, U, P, C) can be saved.
Regarding how to initialize value set, refer to function of "Master Dial".
☞ Selecting job mode : double side laminating -> JOB 1~5, single side laminating -> JOB 6~9, H, user-fixing -> U, P, C
K. Button for selecting cooling fan ON/OFF
To run cooling fan. When pressing "FAN" button, cooling motor runs, when pressing the button one more time, it stops.
During the time of laminating large quantity, this function is used to protect lamination results from getting wrinkles
by curbing temperature increase of rear roller.
12/25
