HOW TO LAMINATE
◐ LAMINATION
If the test lamination has a good results, increase its speed for lamination.
※ This machine contains special speed and temperature control program to improve lamination quality.
1. Soft Accelerate System
- This program is to apply the change of the job speed within 4secs if the job speed is rapidly increased.
This delays the temperature decrease caused by the high speed rotation to prevent the low temperature that causes deterioration of laminating quality
2. Temperature control program
- the heater would be linked with speed to compensate the heat of the roller faster while the roller is on the job.
※ Notice for Lamination
1. Stop while lamination job could make mark on the laminated results.
2. Basically, the thicker substrate requires the further slower speed and the higher temp.
3. Basically, the thinner substrate requires the further faster speed and the lower temp.
4. If it requires to have the exact lamination condition but no / rare test materials, set conditions with the similar materials firstly.
after on, check its required estimated conditions to the lamination.
5. If a sheet would not be fed into the feeder, this will be a cause of wrinkle on the laminated results.
Start
(Speed 3)
KEY IN
(SPEED 10)
4sec
4sec
4sec
Example)
Starting job with a speed of 3 and increase the speed to 10
① The speed message will blink while changing the speed
② The message will no longer blink when the speed reaches
the set speed.
Remarks
:
If the temperature of the roller is lower than the set temperature while increasing the speed, the speed will not increase from
that point and "
temp
L
" message will appear on the display. This message will be disappeared when the compensation
of the temperature is made. Please increase the speed again after the "L-TEMP" message disappears.
30/48
