HOW TO LAMINATE
☞ Preparation for Lamination
1. Turn on the machine and the system is operated.
2. Set up for Control Panel
1) press the "PAPER LENGTH" on control panel and set up the length of substrate with Master dial.
2) Press "TEMP" on control panel and set up temp. withMaster dial.
NOTE :
Basically, set temperature for POLYNEX FILM is 100~115℃, for NYLONEX(PERFEX)FILM is 110~130℃.
3. How to load film
1) Insert a film roll into the film shaft. Then, place the film shaft holder and insert the fixing pin.
Procedure
① Remove the Film Shaft Holder Fixing Pin.
② Pull the Film Shaft Holder.
③ Insert or Remove film roll into or from Film Shaft.
- Insert a film roll into the film shaft after the holder fixing pin is removed.
- Tighten the Film core fixing bolt after film is loaded. (Use the 5mm wrench in the packing.)
NOTE
: Use 5~10mm short width films than substrate. If the film width would be
wider than substrate, this could be a cause of contamination on roller / of cutting error.
2) Insert a substrate for loading from the laminating roller till the pull roller.
NOTE :
substrate must be passed the decurler.
27/48
