FRONT ROLLER PRESS / RELEASE
: Push to close or release the roller gap
VACUUM
: Toggles between turning on the vacuum fans, installed inside the front table,
and turning them off.
COOLING
: Toggles between turning on the cooling fans, installed under the laminating web,
and turning them off.
START
: Push to start running the unit
STOP
: Push to stop running the unit
REVERSE
: Push to run the unit in reverse. Keep it pressed to keep it running in reverse and
audible beep will sound while pressed
Select Key & Jog Dial
Controls
This part is to control the laminating
speed and mode of the unit. Should
operator desire to change the Top
Temperature, press TOP
TEMPERATURE key and turn the
Jog Dial left or right to set the
desired temperature. LED on left of
those keys shown will indicate if that
particular setting is chosen to
change. Turning the Jog Dial will
change only the setting by where
LED is lit.
TOP TEMPERATURE
BOTTOM TEMPERATURE
SPEED
JOB MODE
Control Buttons
11
OPERATION OF CONTROL PANEL
TEMPERATURE Display
Top & Bottom temperature can be displayed and set from 0~160
SPEED Display
Laminating speed can be set from 1 to 10 (relative scale) corresponding to minimum to
maximum of 3m/min for 1600HR and 5m/min for 2100HR.
RUN TIME Displays
Displays time the unit has gone under operation. It will be re-set to “00:00” once the power
of the unit is turned off.(“Hours:Minutes”)
MODE Displays
Shows various laminating and mounting modes and all the major laminating parameters
such as roller temperature, roller gap, speed, fan power will be adjusted accordingly.
A. High-Prs Lami B. Mid-Prs Lami C. Low-Prs Lami D. 03mm Mounting
E. 05mmMounting F. 07mmMounting G. 10mmMounting H. 15mmMounting
I . 20mmMounting J. 25mmMounting
For cold lamination, there is no pre-set setting programmed in the laminator.
Operator should manually set the temperature to 40
at the Mid-Prs”pre-set.
Note) Cold Film thickness less than 50mic : “High-Prs”mode
Cold Film thickness over 200mic : “Low-Prs”mode
Message Display
Generally shows the temperature of each top & bottom roller and changes according to
the status of the unit setting. Details will be reviewed again later on.
Vacuum Fluorescent Display (VFD)
MODEL
GraphicMaster-1600HR
GraphicMaster-2100HR
1 2 3 4 5 6 7 8 9 10
0.4 0.7 1.0 1.3 1.6 1.85 2.1 2.4 2.7 3.0
0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0
(m/min)
12
