Model No. 8047D, 8048D, 8049D, 8050D, 8051D
Electric Fryers
8066, 8068, 8068FL, 8073, 8073BF, 8075
Page 6
gmpopcorn.com
Setup
This unit has been tested at the factory.
1.
Remove all packaging and tape prior to operation.
2.
Place the fryer in a protected location on a level, sufficiently stable base or table,
where it cannot be knocked off. The base or table must be strong enough to support
the fryer when full of oil.
3.
Remove the tank cover (if provided) and accessories from the unit.
4.
For shipping purposes, the Power Head is oriented on the drain side of the tank. To set
up for use, orient the power head to sit
centered
of the back rim of the tank (side
opposite of the drain) reference image below. Ensure the head is correctly seated on
the rim to engage the Power Head Safety Switch.
The unit will not operate if the
Safety Switch is not depressed.
5.
Once the power head is positioned, insert the E-Stop Plug securely into the Power
Head Receptacle (located on bottom of Power Head), then twist the plug collar
clockwise by hand until snug, DO NOT overtighten the collar (reference image above).
Insert
E-Stop Plug
into receptacle, then twist
Plug Collar
clockwise by hand till snug.
Plug Collar
Power Head
Receptacle
Bottom View of Power Head
Power Head
Safety Switch
General Fryer images shown for reference.
Power Head Orientation
E-Stop Plug
E-Stop Button
(located
on operator side of tank)
Power Head
Center on back rim of the tank
(side opposite the operator).
Drain Valve
(located on
operator side of tank)
Safety Switch
