OSPREY WATER SOFTENER
INSTALLATION AND ASSEMBLY
INSTRUCTIONS
1 ) To add the plumbing fittings first lift
up or remove the secure fastenings
clips.
Apply silicone lubricant to all the 'o' rings
and push the connectors onto the
bypass assembly. Push down the
fastening clips to secure fully.
Then push the bypass assembly onto
the valve body and secure with the two
stainless steel clips & screws.
BYPASS VALVES OPEN
(softener in service)
BYPASS VALVES CLOSED
(softener in bypass)
PAGE 1
2) Check the bypass valves are open. Use the tool supplied to turn the bypass valves fully clock-
wise. The valves are open when both are parallel. Failure to open these will bypass the water sof-
tener leaving you with hard water.
This Water Softener requires a minimum water pressure of 1.7 bar and a maximum water pressure of 5
bar. If the pressures are outside these parameters then please contact us before installation.
3) Locate the waste fitting on the control valve. Using
15mm flexible tubing, connect the waste fitting on the
control valve to a suitable drain connection.
Secure the waste tubing with a hose clip. Make sure
the red securing fastener on the waste fitting is
securely in place.
