Levelling
"
If you are installing a processor to be used for online processing, please refer
to the separate “INTERFACE MANUAL” for additional details about specific
processor height.
"
The machine must be placed on a steady surface, so that it does not shake
easily and the chemicals cannot be spilled from one section to the other.
"
Do not rely on the floor being completely level.
•
Use the adjustable feet
(1)
in the legs to level out the processor. The counter nuts
(2)
must be loosened before adjusting the feet and tightened properly when finished.
•
You will need a crowbar or similar
(3)
to lift the legs slightly before being able to
turn the feet and counter nuts.
•
Level out the processor lengthwise by placing a spirit level on the left and right tank
side.
•
Level out the processor crosswise by placing the spirit level on a roller at the front
and rear of the processor.
•
Check levelling in all four positions and make final levelling if required.
•
Level out the preheat section with the appropriate screws.
Install processor interface
"
The interface can be either a feed table or a setter interface.
Whether or not the processor is already fitted with some kind of interface panel you
should refer to the separate “INTERFACE MANUAL” for installation instructions and
other information relevant for your present type of interface.
Installation Manual - Plate Processor 150
1049
2-24
Installation
Preparation for processing
