Champ
™
3 & Champ
™
5 Hot Melt Glue Gun
Glue Machinery Corporation™
4234 Boston St, Baltimore, Maryland 21224
Toll Free 1-888-202-2468 | Phone: 410-761-2727 | Fax: 410-761-5127 | Email:
8
Application of Hot Melts
Only start glueing when the glue has properly molten.
Make yourself familiar with the instrument first. Apply a little glue in varying forms (small, large dots) on a piece of
paper or cardboard. Observe the correct working temperatures of the individual hot melts.
Never start working without having mounted a nozzle!
Press the trigger only when gun has warmed up!
Vent in the corner must, by all means, be left open.
Nozzle Replacement
Only replace nozzles when the glue gun is warm (instrument temperature 60 - 80 °C) and empty. You are advised to
wear protective gloves.
Prior to exchanging nozzles, unplug connecting cable!
Replacing a cold nozzle may damage the gun. If the nozzle is replaced when it is too hot, liquid adhesive may leak
out.
Attention: Risk of burning!
-
If your skin contacts with hot glue, cool it immediately with cold water.
-
Do not try to remove hot melt from the skin first. If necessary, consult your doctor.
-
If hot adhesive gets into your eyes, immediately cool them under running water for about 15 minutes.
Consult
your doctor at once!
Never start working without having mounted a nozzle!
Do not direct glue jet towards people!
