DANUBE 2 R500
48
www.glomex.it
E
N
GL
ISH
7. Mount the coaxial cable onto the antenna:
- make sure that the cable core is correctly
inserted in the central hole of the female
connector on the antenna (otherwise, there
would be a short circuit and the fuse installed
on the power supply line inside the control
unit would trip, see page 63 for fuse
replacement);
- manually screw in the ring nut of connector F;
- once the ring nut has been manually screwed
in, tighten by ¼ turn by means of a 11 mm
wrench;
- insert the protection;
- make the coaxial cable pass through the
previously bored 12 mm hole on the boat.
NOTE: For the connection of the antenna
coaxial cable, it is not necessary to remove the
dome!
8. Insulate with appropriate sealants the holes
drilled in order to prevent the passage of water.
Should it be necessary to shorten the cable,
please refer to the instructions given in Fig. 12.
Central hole of
female connector
Fig. 10
Central cable
conductor
Fig. 11
GL00095
Fig. 12
