Page 13
Operating Instructions
14. Once the set marinating time or vacuum percentage has been selected, close
the lid to start the vacuum cycle.
Note: The vacuum packaging machine will countdown the set minutes
for marinating.
15. At the end of marinating, the vacuum packaging machine lid will open and the
vacuum sealing bag will be sealed.
Note: To stop the marinating process in progress, select the ON/OFF
display button. The lid will open without sealing the vacuum
sealing bag.
Note: To stop the marinating process and seal the vacuum sealing
bag, select the PUMP CYCLE button.
16. Select the SET button. Display will show current seal setting (Figure 13-1).
17. Select the ''up'' or ''down'' arrow buttons to increase or decrease the time of
sealing (tenths of a second, between 0 and 9.9 seconds).
18.
Select the SET button to confirm the setting or select the next option.
Note: If no other options are available, display will return to the
program number modified.
VACUUM PACKAGING MACHINE OPERATION MODEL GVP20A
Do not operate vacuum packaging machine without
first checking/installing oil into the motor/pump.
Damage to vacuum packaging machine will occur.
1.
Place one or two of the filler plates in the vacuum packaging machine in
order to level the product with the height of the sealing bar (Figure 13-2).
Note: Filler plates can be used to reduce the required vacuum time.
Filler plates take up space, leaving less air to be removed from
the vacuum chamber.
2. Place the vacuum sealing bag (or bags) with the product, inside the vacuum
chamber.
3.
Position the vacuum sealing bag with the opening flat on the sealing bar
(Figure 13-3).
Note: Any excess top portion of the vacuum sealing bag should be
placed between the vacuum chamber wall and the sealing bar.
Note: Make sure to place any vacuum sealing bag that contains liquids
or wet product below the height of the seal bar.
4. Turn on the ON/OFF switch to power on the vacuum packaging machine. The
ON/OFF switch light will illuminate (Figure 13-4).
5. Refer to Program Settings in order to select the correct settings for the
vacuum chamber.
6. Once settings have been selected, lower the lid to start the vacuum cycle.
When lid if fully closed the vacuum cycle will begin.
7. If at anytime during the vacuum cycle the vacuum cycle needs to be stopped,
select and hold the ON/OFF display button for 3 seconds (Figure 13-5).
Figure 13-1
Figure 13-4
Figure 13-2
Figure 13-5
Figure 13-3
Summary of Contents for GVP20
Page 2: ...Intentionally Left Blank...
Page 4: ...Intentionally Left Blank...
Page 18: ...Intentionally Left Blank...
