59
ST150M User Manual
Confidential & Proprietary Information
9150-0125-01 R-1
Radio Astronomy Site Avoidance
The ST150M complies with FCC CFR25.213. The customer end-product must comply with the requirements for Radio
Astronomy avoidance. See Globalstar document GS–07–1248 REMOTE TELEMETRY SERVICE FREQUENCY PLAN FOR
SIMPLEX TRANSMITTERS for more details.
Regulatory Notices
The ST150M Board has received Federal Communications Commission authorization under FCC Rules Part 25 and Part 15C
as a modular transmitter. Final installation must be in compliance with 25.213 (see section 6 above). Integrators must complete
final end-product certifications dependent upon their end application’s use. The installation and operating configurations of
this transmitter must satisfy MPE categorical Exclusion Requirements of 2.1091. The antenna used for this transmitter must
be installed to provide a separation distance of at least 20 cm from all persons and must not be collocated or operating in
conjunction with any other antenna or transmitter.
The ST150M module will satisfy FCC/IC modular transmitter requirements only when used with the antenna type specified
in Section 2.6. No power amplifiers may be used under the terms of this modular approval. No trace antennas or any other
type of antenna are approved for use under the terms of this modular approval. It is permissible to use different antenna
manufacturers provided the same antenna type that has similar in-band and out-of-band radiation patterns and antenna gain
(equal to or less than the antenna gain listed above) is used. The module provides a surface mount pad for the RF output
which must be internally attached passively via the PCB to the approved antenna. No antenna connector, cable, or any other
type of antenna may be used. In order for any device to obtain certification from Globalstar for use on the Globalstar satellite
network under this modular approval, all conditions listed above must be met. Use of any antenna other than those listed
in (LIST SECTION/ANNEX) will require proof of compliance (peak gain). This device contains license-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
NOTE:
Any additional host device the module is integrated into will require regulatory testing and certification (C2PC for FCC
and C4PC for ISED).
The ST150M BOARD module has been labeled with its own FCC and Industry Canada (IC) ID numbers, and if the FCC/IC ID
numbers are not visible when the module is installed inside another device, then the outside of the finished product into which
the module is installed must also display a label referring to the enclosed module:
13. REGULATORY
