2) RS232(DB9):
Connect to a PC or control system with D-
Sub 9-pin cable for the transmission of RS-232
commands.
Note:
The RS-232 interface can control the machine.
3) IR IN:
Connect with the supplied
wideband IR RX
4) RS232(3.81mm 3P captive screw connector):
Connect to
a PC or control system with a D-Sub 9pin to 3P cable.
Note:
The RS-232 interface only with the remote receiver
(HDBaseT Receiver) RS-232 communication.
Part5: UPDATE PORT
Connect U flash drive, system software update.
Part6: DC POWER INPUT
Plug the 12V/2.5A DC power supply into the DC12V power in.
6. Remote Control
1. Press this button to power on the
switcher or set it to standby mode.
2. Input Selection: Press these
buttons to switch to the required
source.
3. Audio select: Click these buttons
to select audio from digital (INT) or
analog (EXT), when the signal is
switch to the HDMI or DVI signal
source.
4. Press scaler or auto adjust button
to adjust the output
picture.
Note:
a .
The output signal
source must be
Ver1.1 Page 7 of 21
