Globaljig Evolution, User Manual

Page: 27 / 48

25
5.3 Operating procedures
Below you will find the operating procedures that are to be performed when using
the LB.
a) Turning on the unit
-
Check that the pneumatic supply is present at the control unit inlet.
-
Check that the pneumatic supply is properly connected to the control unit
and the LB.
-
Check for electrical power supply to the control unit.
-
Set the cutoff switch to «I» and check that the green light goes on.
b) Turning off the unit
-
Lower the mobile frame all the way down.
-
Set the cutoff switch to «0».
c) Lifting
-
After having carried out the procedure to turn on the unit, check that there
is nothing to prevent the LB from being lifted.
-
Check that the vehicle on the LB (if present) is securely locked in place
with the clamps and correctly resting on the rubber pads.
-
Press the button (6, fig. 5.1) and keep it pressed until the LB has reached
the desired height. Then release the button.
-
Press the button (5, fig. 5.1) to lower the LB until it stops. Then release
the button.
! ! ! DANGER ! ! !
Before approaching the LB to perform the necessary operations on the vehicle,
turn the selector (3, fig. 5.1) to «0».
d) Lowering
Before lowering the unit, make certain that there is nothing under and/or to
the side of the LB that would prevent it from being lowered.
-
-
Operations for lowering
-
-
Press the raise button briefly to disengage the mechanical safety catch
device.
-
The lowering button has a double action mechanism: the first
opens the outflow solenoid valve, while the second disengages the
safety catch device.
-
Next, press the lowering button and hold it down until the desired position
has been reached.
-
! ATTENTION! !
-
Make sure that the button panel’s cable does not pass through the frame.
↑
↓