![background image](http://html.mh-extra.com/html/global/989021/989021_operation-maintenance-repair-parts-list_2232563033.webp)
BL-GL22-1119 - 11-20-2019
4-15
4-2.8. Diagnostics and Troubleshooting.
Parameter
Factory Setting
Description
BDI MENU - Continued
Start Charger
Voltage
28.1
Voltage above which the battery is considered to start
charging.
Note: Allowable range is restricted by the Full Voltage and Full
Charge Voltage settings.
Reset Voltage
36
Voltage at which the BDI calculator will be reset to 100%, after
the charger is disconnected and the controller is powered up.
Note: Allowable range is restricted by the Full Voltage setting.
Discharge Factor
10
Discharge rate of the battery. Larger values are for larger bat-
teries, which discharge more slowly.
Charge Factor
10
Charge rate of the battery. Larger values are for larger batter-
ies, which charge more slowly.
Low BDI Level
100%
Sets the battery charge level at which maximum vehicle speed
will be limited in order to protect the battery from deep dis-
charge.
Setting Low BDI Level to zero disables this function and allows
the battery to discharge completely.
Low BDI Max Speed
100%
Sets the maximum allowed vehicle speed when the battery
charge falls below the programmed Low BDI Level.
COMPENSATION MENU
IR Comp
90%
Sets the motor load compensation. Higher values provide
stronger disturbance rejection, while lower values provide
smoother operation.
Note: Allowable range is restricted by the Anti-Rollback Comp
setting.
Anti-Rollback Comp
125%
Sets the motor load compensation after the throttle is released
to neutral and the speed is estimated to be near zero. Higher
values provide more hill-holding force.
Note: Allowable range is restricted by the IR Comp setting.
MISCELLANEOUS MENU
Sleep
60
Sets the delay time between the last throttle request or serial
communication and when the controller goes into sleep
mode. Setting the delay to zero disables the sleep function
Fault Code Type
2
This parameter selects which set of fault identification codes
(Type 0,1, or 2) will be flashed by the status LED.
Reset Drive Time
OFF
The controller’s hourmeter logs the total drive time since the
last reset; this record is accessible through the Monitor
menu. Setting this parameter ON zeroes the hourmeter and
starts a new log; this is typically done when the vehicle is ser-
viced. Reset Drive Time is automatically set to Off after the
hourmeter is reset.
Summary of Contents for 989021
